PEEK thin rod (φ3-9mm)

PEEK rod: diameter 3~260×1000 (3000 can be customized according to requirements) (If it does not fit the above...

PEEK extruded rods

Continuously extruded PEEK rods are widely used in small batches of large sizes or in the machining of products that cannot be achieved by injection molding and other processes. PEEK rods with a diameter range of 3-260mm can be extruded and produced, and the length is generally 1000mm, 2000mm, 3000mm. There are nearly 100 types of extrusion dies with complete specifications and inventory all year round.

7221585120964525

PEEK rod small size specification table (I)

Serial number	Rod diameter (mm)	Weight per meter (g)
Serial number	Rod diameter (mm)	PEEK5600G	PEEK5600CF30	PEEK5600GF30	PEEK5600LF30
1	5	31	33	34	33
2	6	42	45	47	46
3	8	70	77	80	78
4	10.5	118	129	135	130
5	12.5	164	180	189	183
6	15.5	250	275	289	278
7	18.5	354	389	410	395
8	20.5	434	477	502	483
9	22.5	522	573	604	581
10	25.5	669	735	775	745
11	28	805	885	933	897

PEEK Extrusion Line

PEEK rod: diameter 5~200×1000 (3000 can be customized according to the requirements) (If it does not fit the above specifications, our company can supply the product size, length and width specifications and can be cut to size)

62158494922761

2201584949243129

1631584944548144

PEEK is a high temperature resistant thermoplastic with a high glass transition temperature (143°C) and melting point (334°C). Its load thermal deformation temperature is as high as 316°C (30% glass fiber or carbon fiber reinforced grades).

PEEK5600G (brown gray/khaki) is made of pure polyetheretherketone resin, and has the best toughness and impact resistance among all PEEK grades. Pure PEEK can be sterilized using convenient sterilization methods (steam, dry heat, ethanol and Y-rays), and the raw material components used to make PEEK comply with the EU and US FDA regulations on food compatibility. These characteristics make it very widely used in the medical, pharmaceutical and food processing industries. 2. PEEK5600LF30 (black) is a bearing-grade plastic made by adding PTFE, graphite and carbon fiber. Its superior friction properties (low friction coefficient, wear resistance, and higher peak pressure limit) make it an ideal material for this level of friction applications.3. PEEK-5600GF30 (brown gray): This material is a reinforced plastic filled with 30% glass fiber. It has better rigidity and creep resistance than PEEK, as well as better dimensional stability. It is ideal for manufacturing structural parts. It can withstand fixed loads for a long time at high temperatures. If PEEK5600GF30 is used as a sliding part, its adaptability should be carefully checked because glass fiber scratches the mating surface.PEEK-5600CF30 (black) This material is filled with 30% carbon fiber reinforcement. It has better mechanical properties (higher elastic modulus, mechanical strength and creep) and is more wear-resistant than PEEK5600GF30. In addition, carbon fiber reinforced plastic has 3.5 times the thermal conductivity of unreinforced PEEK plastic and dissipates heat from the bearing surface faster.